Stator cover

[Billy Busa]

I know this is a busa forum but I have a Kawardsucky ZZR-600 and am trying to replace the stator cover.

The bolts holding the coil inside wont budge and im afraid i might strip the bolts.
The bolts are torq type and im using a torq type screw driver.

Does any one have any ideas on how to loosening those bolts to get the coil out?

 

[rockadaous]

get torx bits for your ratchet

 

[Aquaman]

Use a plumbers torch and heat them up. this will loosen up the loctite

And use the torque bit on the ratchet as suggested.

 

[BigBSBusa]

Heat works wonders for tight bolts.

 

[Billy Busa]

Thanks guys, I will try torch and ratchet

 

[Aquaman]

Let us know how you make out.

 

[Mr Bogus]

no impact driver? (uses a driver with a hammer) is all we ever used on dirt bikes (forever throwing parts off otherwise)

 

[Billy Busa]

There is three bolts,I got two bolts out and stripped the other. I guess I will buy an impact driver and see what that does. Thanks guys.

 

[Powers739]

Lefty Loosie...

 

[Spudley]

Stripped one

.....Hmmmmmm.......take a dremel with a cutting disk, cut yourself a slot wide enough for large-flat head screwdriver, and whip that sucker out of there....