Simple question.

[Kat99]

I have never owned a Busa so Im just wondering,on an 08+ model,

Does the rear seat cover fit with the rear seat installed( ie just covering it up) or do you have to switch between the rear cowl and the seat. ( ie one or the other)??

[RaiderDm]

You have to swap them out.
Also when using the hump ( cover ) you have to remove the grab bar ( wing ).

My bad the Gen II doesn't have the wing.

Raider out.
P1588

[slash]

both do not fit at the same time, one or the other.

[carlsbadbusa]

Swap out, 2 seconds....??? why would you want both on ???

[BA BUSA]

You have to swap them out.
Also when using the hump ( cover ) you have to remove the grab bar ( wing ).

My bad the Gen II doesn't have the wing.

Raider out.
P1588

The Gen2 does have a grab bar.

The seat fits with the bar installed, as stated you have to remove the seat to install the hump...also you have to remove the bar when you install the hump. There is a mod so you can use the hump and bar together.

[dadofthree]

I just leave the grab bar off, that works too.

[Dennis The Menace]

One good thing about the hump is, well maybe not a good thing. People like to shove stuff in their hump..

But like others said, easy 10 second swap. But if you get caught out somewhere without out the seat on and someone needs a ride, your screwed.

[DEMMYM]

As mentioned above.

One or the other and it only takes a matter of seconds to swap them out.

However / If you want to run the Hump with the grab bar you will have to do what is called the hump mod, Basically cut out a couple slots so the grab bar does not hit the Hump.