New Grips and Bar Ends

[Djxtrodinaire]

So Thanks to Sleepless Red...my shopping spree has started again

Bought me Harris Grips and HVMP Bar ends
I used to have the Kury but they were not helping at all with the buzzing....

New grips looks good!
However when I was trying to install the Throttle side grip onto the tube, the plastic has chewed away the inside of the harris grip
And on top of that, when i was twisting the grip to line it up, I snapped the Switch housing pin that makes it stay in place

Any solution other than buying a new switch housing?

Thanks for any input.

[Djxtrodinaire]

K thanks for the help!



Temporary fix, wrapped electrical tape around the bar and clamp the housing switch as tight as possible. So far it is staying put....

[coreywiley]

nicely done

[DR1300R]

My pin snap off a long time ago.. Havn't any problems with at all, Just tighten the screws up real good.
grips and bar ends look pretty good..

[BusaWizard]

Nice look.

[Wayneovich]

Me likey where did you get the bar ends?

[Djxtrodinaire]

Me likey where did you get the bar ends?

Thanks!

HVMP dot com

[UncleSteve]

Do they have bigger ones?

[Djxtrodinaire]

do they have bigger ones?

???

[Djxtrodinaire]

Well I rode it to work and the buzzing seems less.

Will find out soon after work do a quick workout with it.