need help

[1127 TO 1299]

Last night i installed my scorpiop alarm.

I just could find where to plug the 2 gray wire on the suzuki harness. They are supposed to be connected to the left/right turn signals.

But where to you actually make the connection?

BTW, very easy to install besides those 2 gray wires.

 

[ks-waterbug]

I believe you have to splice into those wires if you're not running the stock set-up. Otherwise I believe its a plug n play operation; Been awhile since I did this.......

Help from the board



<!--EDIT|ks-waterbug
Reason for Edit: None given...|1085063850 -->

 

[Haywood]

You need to use the connectors supplied to splice into the turn signal wires IF you want the turn signals to flash (which isn't mandatory). The connectors will turn into a female connector once crimped together allowing for the male end to mate up with it.

 

[1127 TO 1299]

haywood
i think i got it
this is what they are for those redish connector
when you close then around the wire you can see an slot where the grey wire can connect.

Thanks

 

[Haywood]

you got it.. no problemo- glad to help.