Mapping Needed?

[fallenarch]

I had a custom map done for the busa when it only had the R-77 slipons. Now I am headed back to the dyno with the full R-77 4-2-1 system. Is it ok to ride it to the shop (about an hour ride on the interstate) with the current map for the slipons or do I need to get something close to right for a full exhaust even for the ride to the dyno?

[Big E]

You will be fine.

[kromdom]

You will be fine.

I agree. Is current tune on a PC? If YES, maybe load this map on the way over: 20-008-004 Yoshimura R77 full exhaust , Stock air filter

[methyman]

I had a custom map done for the busa when it only had the R-77 slipons. Now I am headed back to the dyno with the full R-77 4-2-1 system. Is it ok to ride it to the shop (about an hour ride on the interstate) with the current map for the slipons or do I need to get something close to right for a full exhaust even for the ride to the dyno?

I have a map for the R77 exhaust for ECU editor that I got from a member that Johny Cheese tuned. I have it if you need it.

[Blanca BusaLess]

Just take it easy on way over. You'll be fine.

[fallenarch]

Knowing my luck I'll get over there fine and then drop it in the parking lot

I think I'll just ride it as is and get it dynoed. This will be interesting because i have a dyno run both stock with slipons and now with full Yoshi. Should be a good comparison. It did 171 whp with the slipons.

[dadofthree]

Make sure you throw the results up, and don't drop it

[fallenarch]

Just for that I'm going to PM everyone on the org but you with the results.