Map Question PC3

[m2cyclone]

Im using a map file that one of the guys on here sent to me. It seems to work fine for my setup, but at 0% throttle, it will sometimes stall.
Most of the time when pulling up to a light, when I pull the clutch in it will stall or sometimes when you rev it up and then go to 0% it will stall.

Also at idle it seems to be running a little rough and my RPM is I would guess around 800 to 900.
If I use the fake choke or give it a little throttle it clears up.
She is also very cold natured, but I'm guessing it is the map causing that too.


I have Full 421 Muzzy, KN air filter, Airbox mod, pairvalve mod(gone).

I tried the standard Muzzy file from PC3 site, but it was too rich.

Any ideas on what I should change in the map to stop this.

thanks

 

[Johnnycheese]

idle is 1300

 

[m2cyclone]

then my idle is way off then.. tach shows about 900..
how to fix that?

 

[CTA_Busa_LE]

To adjust idle, you need to get the bike to operating temp then lift the tank. To lift the tank you will need to remove the seat first then remove the two bolts at the front of the tank then simply lift it and prop it up with the prop rod that should be in your trunk. You will then see the adjustment screw. Fire the bike up and tweak it to where you need it.

service manual calls for idle to be between 1050 and 1250 rpm. I run mine at 1100, seems to be where it likes it the best.

 

[m2cyclone]

Duh,

I guess I was over thinking it and thought the PC3 controlled that.. forgot about the idle adjust screw..

thanks