Pc3 From Gen 2 To Gen 1?

Discussion in 'Engine and Performance mods' started by Bluey2, Aug 20, 2017.


  1. Bluey2

    Bluey2 Registered

    Contests won:
    0
    Messages:
    15
    Will a Gen 2 PC3 fit the connections of a Gen 1? Been offered one and if it connects I guess it is just a case of adding the correct map?
     
  2. Bluey2

    Bluey2 Registered

    Contests won:
    0
    Messages:
    15
    Anyone know?
     
  3. PADEROLIS

    PADEROLIS Registered

    Contests won:
    0
    Messages:
    2,688
    Location:
    LAS VEGAS
    Went to the Dynojet website: The part # a 2007 Gen 1 PC3 is 312-411
    A 2008 Gen 2 is 339-411. They wiring is different too, the Gen 2 PC3 has connectors for the 8 injectors.
     
  4. Bluey2

    Bluey2 Registered

    Contests won:
    0
    Messages:
    15
    Ah ha, lovely, thanks for the info.
     
  5. POWERHOUSE

    POWERHOUSE Frank Site Sponsor Registered

    Contests won:
    0
    Messages:
    2,307
    Location:
    east coast
    No it doesn't. The PCV and PCIIIusb connect to the four lower injectors only . . .
     
    PADEROLIS likes this.
  6. Bluey2

    Bluey2 Registered

    Contests won:
    0
    Messages:
    15
    Ok.......

    So does that mean it may fit?

    My understanding of the DJ part number is that it can either relate to the DJ installed zero map only, or the connetors and the map. If the connectors are the same then a later PC could simply be reprogrammed?
     
  7. PADEROLIS

    PADEROLIS Registered

    Contests won:
    0
    Messages:
    2,688
    Location:
    LAS VEGAS
    My apologies; thank you for the correction, sir!
     
  8. PADEROLIS

    PADEROLIS Registered

    Contests won:
    0
    Messages:
    2,688
    Location:
    LAS VEGAS
    The connectors appear to be different between the PC3 for a 07 and a PC3 for an 08, at least from the images I've viewed on google. I had one in my 07 Busa and I have one in my 08, the setups are different.
     
  9. POWERHOUSE

    POWERHOUSE Frank Site Sponsor Registered

    Contests won:
    0
    Messages:
    2,307
    Location:
    east coast
    The injector connectors themselves are way different, Gen 2 connectors are smaller.
     
  10. Bluey2

    Bluey2 Registered

    Contests won:
    0
    Messages:
    15
    Ok. That's that cleared up.

    Thanks. :)
     

Loading...

Share This Page