I was browsing and found this. Thought I'd share

[busaville]

If it sounds to good to be true then it probably is.... don't waste your time and MONEY.....

 

[riccoh]

I seen those in person, fit, finish and graphics are horrible, paint is shiney only until you start the bike and heat it up for ten minutes. the plastics actually melt to your exhust and the paint bubles around every opening surronding the engine. the inside panels don't line up. and the paint is just ontop of a gel coating there is no prep for paint... you can litterally peel it off.. I have never seen anyone so desapointed as we watch his $994.00 go to wast in lest than 22 minutes. the only upside is that once the botom plastics melt to your exhust it gives you that ground clearence of a xr1k.

 

[BusaWhipped]

Wouldn't be bad as track plastics even if the fit and finish is off a bit.

 

[semperfi]

China? Uh-Uh!