Hayabusa 2001 ignition switch

[thbu1]

Hello, I'm new here and I'm from Germany.
Drive a 2001 Haya and a 650 Deauville.
My question is:
I would like to install the Motogadget M-Lock on my Haya Gen 1 from 2001.
Switch on ignition with RFID.
I would be grateful if someone could help me:
From the ignition lock, the power cables must be connected to the M-Lock.
I understand that and it's no problem.
But what about the B/W ground wire on the ignition switch that goes to the ECU? Is the ground switched
or is it permanently on and can therefore remain on the ignition lock?
Unfortunately no one has been able to answer that for me so far.
Greetings from Germany
Thomas

 

[GIXERHP]

B/w needs a 100 ohm resistor then to ground
As well you should add a relay to switch the resistor to ground as a fail safe

 

[thbu1]

Thank you!!

Sorry I couldn't reply earlier.
Solder a 100 ohm resistor to black and white.
Then connect it to terminal 87 of the 2nd relay?
Orange white comes on terminal 30 of the 2nd relay?
The M Lock then switches both relays for voltage and ground.
Did I describe all of this correctly?
Please excuse my bad english.

Greeting
Thomas