Gen1 Clutch in a Gen 2?

[mestona]

So before my Gen 1 was hit I bought a Barnett Carbon Fiber Clutch kit for my bike. Is there anyway to use it in a gen 2? Can it be modified in someway to make it work?

[Commuta_Busa]

as long as the stack height falls within spec you're good.

[mestona]

Humm....I thought one of them uses less plates than the other? I think the gen 2 uses one less friction and one less steel than the gen1? If that is the case could I just remove a friction and steel from the kit? Thanks for the help

[Commuta_Busa]

well I use the fibers and steels for a Gen2 on my Gen1. I'm pretty sure they have the same count. I don't count them often anymore just concentrate on height.

[mestona]

Good to know. Do you buy them as a kit? If you do do you use the whole kit?

[Commuta_Busa]

yup, I buy and use the whole set. Ok, now you got me curious... let me go cehck this out real quick.

[Commuta_Busa]

same amount of fibers so there are the same amount of steels in between. I would still check your height to be sure everything is right.

[mestona]

Thanks again, now I don't have to sell the clutch I've had kicking around for a few years