I have my lower cowlings off, and am going to install T-Rex no-cut frame sliders on my 2009 Busa.
Do I need to put a support (jack) under the engine or will the engine stay in place doing one side at a time.
thanks, Mike
it will saty in place but i still reccomend doing one side at a time and dont fully tighten any bolts untill everything is connected together I have them on my 07
Thank you vigorblue. I was afraid of the engine dropping down out of alignment with the frame holes. I plan to loosen only one side at a time and replace them one at a time.
Take care not to disturb at all the hose which leads oil(left side) from crankcase to the head ......cause mine(08) untightened at the headside with a leak after a while
I put mine on over a year ago, and what I remember was one of the mounting bolts, felt like it was stretching prior to the click of the torque wrench so I eased off. I would use good judgement when tighning it all up.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.