firebug
Registered
I searched and didn't come up with much . . .
I installed my HMF Big Bird full exhaust on my 02 and the fit sucks. I hope to get a chance to loosen everything up and try again within the week.
Is there any tricks to getting this thing to fit without melting my plastics in multiple places. I have heat shield to install and I think I am going to wrap the tubes but I would prefer to not have them touch the plastics.
The places I have issue with and were they touched and melted are on the left side down pipe and they melted to the right side plastic where the 2-into-1 piece sits. No damage to paint that I have seen but still irritated.
Any suggestions on fit? It seems like when I tighten things down there is not much room for adjustment.
Lastly, anyone have a good map for the big bird? Or recommend which dynojet map would work best until I can afford a custom map.
Thanks.
I installed my HMF Big Bird full exhaust on my 02 and the fit sucks. I hope to get a chance to loosen everything up and try again within the week.
Is there any tricks to getting this thing to fit without melting my plastics in multiple places. I have heat shield to install and I think I am going to wrap the tubes but I would prefer to not have them touch the plastics.
The places I have issue with and were they touched and melted are on the left side down pipe and they melted to the right side plastic where the 2-into-1 piece sits. No damage to paint that I have seen but still irritated.
Any suggestions on fit? It seems like when I tighten things down there is not much room for adjustment.
Lastly, anyone have a good map for the big bird? Or recommend which dynojet map would work best until I can afford a custom map.
Thanks.