I have the HMF High Mount Carbons, just wonder if the 2 extra bends will cause additional back pressure instead of a un-restricted flow out. If it does what are the pro's and con's of this? Thanks for any and all info on this.
Absolutely! Your bike will run terrible and you will be slower than a Honda Rebel 250
I would advise boxing it all back up and sending it to ME immediately for disposal
simply put, Bends = restriction. I cannot believe that 1 extra decreased radius bend per side will be problematic for you perfomance wise. I am comparing that system to a mid-rise exhaust system. I however am not a exhaust officianado but I did stay at a Holiday Inn express last night
super851 I'm no expert on exhaust, but I know for sure that its going to change the performance of your bike. There is this post in the technical section of this board that talks in depth about exhausts... I suppose you might want to check it out
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.