c10
Registered
used a Bike master offset mirror mount with a 90 degree bracket ( soon to be painted black ) had to clearence the braket just a bit to clear the control . Used a CRG bar end mirror mount inside the stearing stem with a thin JAM NUT to hold a GPS mount . Very clean , light , low profile .
You do have to lean in to see FUEL lvl , but I chose the left side over the temp gauge cover up . Best part is it was about $7.50 in hardware to
build/make from scratch .
You do have to lean in to see FUEL lvl , but I chose the left side over the temp gauge cover up . Best part is it was about $7.50 in hardware to
build/make from scratch .
Last edited by a moderator:
