air shifter bottle

[Busaboy1992]

where can i mount the bottle for my airshifter if i dont have a aftermarket swing arm?

[Gixx1300R]

what size bottle?

[Busaboy1992]

the mps bottle

[Gixx1300R]

Need to know what size bottle you are using

[dadofthree]

Trunk, passenger peg area

[GNBRETT]

it will mount fine with a 1 lb bottle or a smaller bottle. u just need to drill two holes and get two clamps to hold it. it will be close to the rear tire but will clear just fine. kinda a PITA to take out but no big deal.

[Ludicrous Speed]

On my Gen1, I mounted the MPS bottle under the tail section on the RH side, by the passenger peg. On my Gen 2 I had a 9 oz Co2 bottle that I took the valve apart and drilled and tapped for 1/8" npt where the pin valve was and also on the burst valve hole. I then mounted it in the same place. THe Gen 2 did not have as much room

[Quicker Gixxer]

9 oz co2 bottle....with regulator, fits like a glove.