1st dyno @ Daytona
- Thread starter viol8r
- Start date
OB_THE MOTORHEAD
Registered
- Joined
- Jan 19, 2000
- Messages
- 1,600
- Reaction score
- 58
he could have printed it in words or graphs.it should read in words what the peak hp was unless its printed without notes.
G
Guest
Had my bike dyno'd @ the hess on Sat
they said the it had 161 hp and they ran it up to 192mph. I'm just a little confused by the print out though. It looks like you have to estimate the HP where the line falls between the dots on the page, from that it
looks like 158-9. they didn't run it up to rev limiter in sixth either. bounced it on the rev limiter in 5th though. on the road it will hit the limiter in 6th. Completely stock no airbox, just drilled the rear plates in the mufflers. 2,197 miles.
It was a DynoJet model 100 dyno.
Would appreciate any comments.
I can scan the Dyno sheet and send it to anyone who is more experienced in reading these sheets
It was about 75 in the trailer and @ 60 ft above sea level.
e-mail me @ mtd@bellsouth.net and I will send the dyno sheet
they said the it had 161 hp and they ran it up to 192mph. I'm just a little confused by the print out though. It looks like you have to estimate the HP where the line falls between the dots on the page, from that it
looks like 158-9. they didn't run it up to rev limiter in sixth either. bounced it on the rev limiter in 5th though. on the road it will hit the limiter in 6th. Completely stock no airbox, just drilled the rear plates in the mufflers. 2,197 miles.
It was a DynoJet model 100 dyno.
Would appreciate any comments.
I can scan the Dyno sheet and send it to anyone who is more experienced in reading these sheets
It was about 75 in the trailer and @ 60 ft above sea level.
e-mail me @ mtd@bellsouth.net and I will send the dyno sheet
Similar threads