lajguess
Registered
I haven’t seen any 08 with this mod so I will tell you how I did it.
I pre-heated the oven to 200 and put the light in for 10 min. pulled it out and pulled it apart with a kitchen knife and razor, the dryer was to keep the glue warm and easy to pull apart. It did take a while to pull apart.
I used a FX-R and TSX projector both with clear lens replacements. I also went with the 6000 D2S bulbs, nice color and not to blue.
After pulling the stock projector out I took a dremel and did some trimming so that I could sandwich the projector in the stock position and be able to use the stock beam adjustments. by sandwiching the projector there it accomplished the washer mod I was going to do anyways.
the top projector I just ran long screws and lock nuts through the housing then aimed it to the stock High beam tape marks I put on the wall then silicone it in place no need for it to move.
this is the finished product, I covered up the holes I cut with a piece of mirror fix sheet I picked up at auto zone. sorry don’t have more pictures of that. I will post pictures of lights a little later. hope this is helpful to someone.
I pre-heated the oven to 200 and put the light in for 10 min. pulled it out and pulled it apart with a kitchen knife and razor, the dryer was to keep the glue warm and easy to pull apart. It did take a while to pull apart.
I used a FX-R and TSX projector both with clear lens replacements. I also went with the 6000 D2S bulbs, nice color and not to blue.
After pulling the stock projector out I took a dremel and did some trimming so that I could sandwich the projector in the stock position and be able to use the stock beam adjustments. by sandwiching the projector there it accomplished the washer mod I was going to do anyways.
the top projector I just ran long screws and lock nuts through the housing then aimed it to the stock High beam tape marks I put on the wall then silicone it in place no need for it to move.
this is the finished product, I covered up the holes I cut with a piece of mirror fix sheet I picked up at auto zone. sorry don’t have more pictures of that. I will post pictures of lights a little later. hope this is helpful to someone.