Haulin Hooter's
- Thread starter RamminBusa
- Start date
So give me your honest opinions
I think I'm going to have to.
So the wing just attaches directly to the tonnue? No other modifications need?
Looks really good.
Went something like this:So give me your honest opinions
I think I'm going to have to.
So the wing just attaches directly to the tonnue? No other modifications need?
Looks really good.
1. Remove the wing from the truck (to include rear mounting studs)
2. Remove cover from shipping packaging
3. Say damn this thing looks good
4. Cut fricking Bedliner with 1, make that 2 dremmel disk's
5. Break two dremmel cutting disk's, cuss, and get sabre saw out
6. Place front hinge assemblies in the front of the bed and tighten down
7. Place rear mounting hardware on bed and cut bed liner again at the rear
8. Tighten rear mounting hardware
9. Make an attempt to lift cover by yourself ....
10. Give up and ask wife for help....
11. Adjust rear hinges so lock works
12. Steal kids silly-putty and spread on rear of cover (both sides where
wing should be).
13. Go to store and buy more dremmel cutting disk's
14. Cut cable and rubber stub off bottom of the wing
15. Place wing on cover and apply pressure to leave marks in putty
16. Remove wing and grab drill with really sharp drill bit
17. Place cardboard or other protective item on bed and lower cover
18. Nervously drill pilot holes in cover indacted by marks in the putty
19. Step to a larger drill bit and drill holes again
20. Place wing on truck with rear studs in the wig
21. Lift cover slightly and replace 10mm screws in the front of the wing
22. Tighten screws ensuring not to over tighten
23. Take dremmel and cut the rear mounting studs flush with the nuts
24. Carefully shut cover
25. Close tailgate
26. Again cuss and remove the tailgate cover (part of the bedliner)
27. Cut top portion off
28. Re-install the inner part of the bed liner tailgate cover
29. Close tailgate and THEN lower cover
30. Get camera and brag
Dodgetalk.Com
