Recent content by spanky31680

for who wants to know why i took it to harley, because there isnt another dyno around me except for st.joe which is another harley shop and they wont dyno jap bikes. my a/f ratio is 13 all across the board.

i know ill get alot of questions so here i go. its got an .080 base spacer, adj cam gears, performance valve springs, and ape studs. ive posted problems that ive had in this journey and ill never do it again. ive built nitrous kits for 7 years and never, never, never had all this drama. for...

after all the bull **** its finally done. here is the dyno sheet

ken at velocity racing said that the factory head bolts are only torqued at 35 ft lbs, when i put the ape studs in i had to torque them to 65 ft lbs, i only ran the bike 1 time through the gears when i found out it was pumping 10 psi in the turbo by then it started pumping antifreeze out of the...

the turbo was set at 10psi unintensionally from velocity, by the time i figured it out it was too late. yes, the air filter sticks out of the left side of the bike and you have to cut a hole in it along with clearence of the pipe to the air box. the exhaust pipe points out of the right side of...

I just installed a velocity racing turbo on my 08 hayabusa, after getting it tuned, im blowing antifreeze out of my resivor, the kit is a stage 1 with 6 psi, i called velocity and they said i may have lifted the head, my question is while im there i want to put a .080 spacer, turbo pistons...

eddie blasche at topeka harley has made alot of maps for turbo, supercharged, and nitrous fed jap bikes and harleys. I guess having heartland park drag strip a few miles down the road he gets alot of off the wall work. He maped my pc for my nitrous set up on my old o1 gixxer 1000 so yeah, he...

I just purchased a stage 1 velocity turbo for my 2008 hayabusa and i was wondering if any one had any tips or tricks on this install. I also purchased a power commander with the map already in it from velocity. I also had them weld the bung for the water injection in the pipe so i can install...