jeepinocala
Registered
lease:Ok here is what I want to do. I have the power commander III USB and the hub for it plus the lcd. I want to wire up my nitrous pos wire directly to the battery and run the ground through the hub so I can control when the nos comes on by rpm and throttle pos and only on my nos map. I have the map switch and two maps loaded on I am useing for rideing around town and the other after I have adjusted at a dyno it will be for nos. Has anyone done this? Is the ground control off the hub good enough for this and the hub groun control it has two of them the second one I want to control an air shifter or electric shifter. Am I in the right doing this or is there something I am missing? Jeep uses their ground wires to activate everything in their vehicles so I figure it is safe as long as I do it right.