What's your current mileage ? Any mechanical weirdness at certain points ?

07BusaPilot

Registered
Joined
May 6, 2013
Messages
17
Reaction score
0
Just looking for people's experience. I'm on an 07 with 9200 km, was told I needed to adjust valves at this point, but the manual says otherwise.

Flicka

Professional Booga Flicka
Moderator
Joined
Feb 18, 2009
Messages
7,078
Reaction score
65
Going by the manual is fine, but doing the work at shorter intervals is a waste of time. I mean obviously it never hurts to check, but you don't need to yet. Most people never need any valve adjustment at all on their Busas, and if they do it's after many, many thousands of miles. I wouldn't even consider it at this point unless you suspect there may be a problem.

rubbersidedown

TURBO-BUSA-RIDIN'-BASTID
Donating Member
Joined
Mar 20, 2003
Messages
19,676
Reaction score
6,712
^ ditto. (my first Busa never needed adjustment)

RSD.

lankeeyankee

Banned
Joined
May 23, 2011
Messages
3,320
Reaction score
30
There is such a thing as over doing maintanence. Each time you mess with something your increasing the chances of tech induced issues.
I am close to 30k miles on my genii and never touched the valves.dont over rev em (11k+). change the oil and brake - clutch fluid with a dose of seam foam and grip it and rip it!!

Busarider007

Registered
Joined
Apr 13, 2012
Messages
218
Reaction score
0
leave the valves alone, regular maintenance, like oils, tires, brake pads and batt will keeping it going for many yrs n thousands of miles. Do we adjust valves on cars every 10k? no.

dadofthree

Seasoned Beef
Donating Member
Joined
Sep 6, 2006
Messages
60,253
Reaction score
2,877
41K miles on my '08 and I've been north of 11K RPMs indicated on occassion ( every ride :laugh: ) ( yes I know that means I was going 70+ :spank: ) It cranks in one to two seconds, runs like a scalded dog ( fast as heck for you yanks and kanucks ).

Stay away Murphy :laugh:

sleepless_red

The artist formerly known as "sleeper_red"
Donating Member
Joined
Sep 27, 2007
Messages
4,968
Reaction score
55
Mine is also an '07. I had the valves checked like every 30K miles.

jch364

Registered
Joined
Mar 19, 2006
Messages
2,630
Reaction score
827
I have an 06 and had the engine rebuilt to a 1397 around 40k, valves were spot on no need for any shims after 40k miles. I think though a top quality oil and oil changes are crucial to this but thats just my opinion

Sous

Donating Member
Joined
Apr 28, 2009
Messages
2,794
Reaction score
5
08 with 32K miles and never needed anything other than regular maintenance. Valves were in spec when checked last.

1bondoman

Registered
Joined
Dec 5, 2004
Messages
829
Reaction score
2
I just worked on an 08 with 18k miles and all the valves were way to tight. Some I couldn't get the thinnest feeler gauge under.

millsy

Registered
Joined
Apr 22, 2007
Messages
6
Reaction score
0
44000 miles had new fork seals , 45000 replaced cam chain tensioner , replaced fuel pump at 46000 miles ... 2 sets of wheel bearings in about 25,000 miles

hayanek

Registered
Joined
Apr 9, 2014
Messages
171
Reaction score
0
as others said,do not touch it! just your oils etc.. unless you are looking for problems

red1100cc

Registered
Joined
Jun 5, 2009
Messages
3,797
Reaction score
28
40,000mi+
been through lots of tires, gallons of oil, a chain or 2, a couple pairs of fork seals, and 3 windshields.

it is time to do the fuel filter mod, and put some fresh tires on her for the season.

pretty minimal for all the miles I have ridden, really.

RedBusarider

Registered
Joined
Jun 12, 2008
Messages
2,530
Reaction score
358
To the OP

Do you have any issues? Is it running just fine? Fast as ever? Smooth as Ever? Starts up easily?

Therefore do like everyone else said DON'T TOUCH THEM.

Regular maintenance is all you need to enjoy your Busa. Unless you want problems........:whistle:
Back
Top