kingbrutis
Registered
Hey quick stupid question. The throttle doesn't snap back like it should. I have tried the adjustments on the throttle cable but havn't gotten it right yet. It sticks just a little. Thanks Joe
Throtlte not snaping back
- Thread starter kingbrutis
- Start date
Make sure the rubber end next to the bar end is not touching the bar end.
Did you get it fixed, most likely cause is what nj said, if you changed to aftermarket grips you may notice this even more.
what have you done recently? mods? maintenace?
the throttle butterflys are all spring loaded,thats where the "snap back" comes from. So, you may have lost a spring or 2,or the cables inner may have snapped, or there is drag on the grip or on the cable,perhaps it somehow became disconnected(the return cable). 1 cable pulls the open, the other pulls back.
Lift tank,inspect.... RSD.
the throttle butterflys are all spring loaded,thats where the "snap back" comes from. So, you may have lost a spring or 2,or the cables inner may have snapped, or there is drag on the grip or on the cable,perhaps it somehow became disconnected(the return cable). 1 cable pulls the open, the other pulls back.
Lift tank,inspect.... RSD.
Similar threads
