Stock 08 dyno run on BAZZAZ Principia

[bigjack7679]

So, I was offered a free dyno run from some good guys i know who just opened up their own shop. They just got the new Bazzaz principia dynamometer. I must say Its a sweet looking machine, but the numbers were way lower than dynojet numbers. My Mint condition(15k miles) busa only did 149.5 hp (88.39 ft/lb) on this dyno, but they say its because its rear wheel horsepower is more accurate than dynojet

And, there were 2 other liter bikes there with slightly higher numbers than mines Also my redline was at 11,000 but the two other bikes were a littler higher. I will be installing my brocks street meg in 2 weeks and tune hopefully a few weeks after that

I know these new bikes are powerful but should they have more HP than my bone stock 08?
Do you think Dynojet numbers are that far off?

My stock 08 149.5 Hp

2011 zx10 akrapovic slipon, catalytic converter delete, ecu unleash, 153hp

2011 bmw, aftermarket slipons,154.8


heres the video from my run. Hard pull starts at 1:18. I will post the Hp/torque map after i scan it in monday.

08 Hayabusa bazzaz dyno run. - YouTube[/url]

Bazzaz dyno
Principia Dynamometer

[Dozerdriver]

The s1000rr pulled more HP then my stock 2012 busa and the ZX10 might also...

[bigjack7679]

The s1000rr pulled more HP then my stock 2012 busa and the ZX10 might also...

yeah, they are bulling hard for sure.

[frisbee]

Those are kind a low for sure. New machine huh? maybe thy don't know how to set it yet

[bigjack7679]

Those are kind a low for sure. New machine huh? maybe thy don't know how to set it yet

yeah, they are low. I found another post on the web where someone experienced the same thing using this dyno.

Just dynoed on a Bazzaz Principia Dyno. - Kawasaki ZX-10R.net

[frisbee]

Of course BAZZAZ could be trying to get you to buy thier fuel programer.

[bigjack7679]

Of course BAZZAZ could be trying to get you to buy thier fuel programer.

Maybe so. I would like to try their products out if I didn't have the option to tune through the ecu

[GoldenChild]

Those readings are way low... How much tuning experience do these new owners have and how much experience on the new machine do they have.. following the screen prompts doesn't make you a tuner or tester, if setup isn't done right..

[bigjack7679]

Here is the map

[bigjack7679]

Those readings are way low... How much tuning experience do these new owners have and how much experience on the new machine do they have.. following the screen prompts doesn't make you a tuner or tester, if setup isn't done right..

They are very knowledgeable mechanics with over 20 years experience working on and riding track bikes. But this dyno is new to them.
Johnny Chesse is 3 hours away and that's who i will be going to for my tune. The Dyno jet is proven and well respected on the Org. No reason to reinvent the wheel.

All bikes ran that evening HP was low but, I wanted to make sure i didnt have a lemon with the zx10 putting down more rear wheel HP

[cwalker2]

The Bazzaz is just a rebadged Dyna Pro dynamometer.

Dyna Pro Dynamometers Ltd