Rear Brake Caliper

[Powers739]

Well, I just typed a long write up and lost it.

So, now this is short.  Bad day, I wasn't paying attention when I pulled the pin and the clips sprung out and I am not sure if I got it back right.

Thanks in Advance...

Sorry, I didn't clean up the little bit of assembly grease I used on the pins during re-installation...and all the oher crap...

[Powers739]

[Powers739]

[MC MUSTANG]

Ted,
Your retaining clips should be on the inside, not the outside...

[Powers739]

Ted,
Your retaining clips should be on the inside, not the outside...

That makes sense to me. (ps you have email...)

[Mr Bogus]

[Powers739]

That's what I am looking for... a picture is worth a thousand words... Thanks, Ted

[DR1300R]

Please tell me you are gonna clean them..

[GSXcite]

Ted,
Your retaining clips should be on the inside, not the outside...

+1, clips on the inside.

[runeight]

Yup. MC got it.

If mounted backwards the pad will wear quickly.

r8

[Powers739]

Yea, I'm going to clean them, but I am going to clean them while mounted on the bike, I can use a toothbrush on them a little better. That's what Winter is for...

As far as wearing them down prematurely...hell I hardly ever use the back brake, I only changed them because I had the pads sitting there (Galfer's) saying "use me...use me" and I never changed them out (14k miles), so I thought it was time to learn....