I was thinking...instead of buying pair blockoff plates could you cut off the ends, weld them, or if u don't have a welder....JB weld the holes? then bolt them back on
I used a piece of flat aluminum stock, cut the pipes of the stock flanges, cut the aluminum to size and drilled holes in it for the studs to go thru. Then I put the stock flanges on top of the aluminum pieces and bolted it all back down. Less than $9 and 30 minutes in the mod.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.