woodlandtechie
Registered
my Busa hates me.......
Following the weekends merryment whenI stripped the fuel pump and throttle bodies for cleaning and general tlc, re-assembled, checked, rechecked then checked again just in case....(I am getting on a bit...)
Went to start the bike, it fired up and holy mother!...ran like a bag of spanners, rough does not describe it.....so killed the ignition...checked again, no fuel leaks, all sensors connected, all vacuum holes good, no splits...start again....splutters it's way into like, wont rev, wont idle.....HELP!!
So this morning Iafter a bit of researching I decided to unplug the IAP senser.....damn thing ran, obviously not perfect but it ran... so tested the sensor and it's dead...voltage does not change at all whatever the vacumm applied.
Is that how these sensors fail...seemingly fine one day than BANG!!
Following the weekends merryment whenI stripped the fuel pump and throttle bodies for cleaning and general tlc, re-assembled, checked, rechecked then checked again just in case....(I am getting on a bit...)
Went to start the bike, it fired up and holy mother!...ran like a bag of spanners, rough does not describe it.....so killed the ignition...checked again, no fuel leaks, all sensors connected, all vacuum holes good, no splits...start again....splutters it's way into like, wont rev, wont idle.....HELP!!
So this morning Iafter a bit of researching I decided to unplug the IAP senser.....damn thing ran, obviously not perfect but it ran... so tested the sensor and it's dead...voltage does not change at all whatever the vacumm applied.
Is that how these sensors fail...seemingly fine one day than BANG!!