I shot temps with a thermal gun, and I was looking (at the hotest) around 325 at 82 Degrees. If it doesnt,
Ill strip it and shoot it again. with High temp powdercoat. but I do like the gloss look. I also like it without the logo it had on it. But I couldnt take the chrome. I have seen it in a flat or satin finish,looks cool, but I prefer the gloss
I powdercoat, so it cost me about 15.00 USD, and 1 hour of my time.
That was just the exhaust though. I also did all the hardware, the rear sprocket, rearsets, pass-sets, and the screws under the hump, because I could see them from the side.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.