Gilles - rear sets and levers - gen 3

[c10]

This very same equipment is a OEM option made by Gilles for various BMW motorcycles . I specked these for my R1250RS at order . The eccentric toe levers are great .

[Fghtnfalcn]

Looking at getting a set next week

[Flows]

Some more colour on these:

They work with the standard length Woolich quick shift strain gauge and linkage for the Gen 3.

The bell crank for the gear extends further back than OEM so can get close to an after market twin system like R's Gear GT. Need heat shield tape on the exhaust.

For tall riders the gear lever is a bit thicker so more prone to hit an aftermarket alloy side stand, for 1st engagement (the adj toe pegs solves this)

I made up some thin rubber washer to mount them to the frame and used Ti fasteners with 272 Loctite for a bit of vibration isolation

[Flows]

Quick update, make sure you pull them apart completely and threadlock everything. Don't trust the factory assembly.. Guess you can figure out how I know.