Genmar Risers and brake lines

VFRcanada

Registered
Has anyone with Genmar riser raised the front end off the ground so that the forks fully extend? Other than wheelies. I had the calipers off and was trying to re-install them. I couldn't even get the holes to line up, the lines where so short. Can somebody check to see if their lines are tight too?
 
I have the 1.5" risers and yes it's tight. I had to roll my clutch lever and brake lever over to slacken the lines up some. The change also fit me better, so it's win win. Look at my levers here.

405645411_jcXi9-L.jpg
 
Back
Top