gauge cluster and lights not working

SCdude

Registered
Joined
Feb 1, 2011
Messages
48
Reaction score
0
Have an 08 using those cheap ass xentec hids. My gauge cluster and lights stopped workin. The only thing workin are the hids and the clock. And the low beams don't come on everytime. Anyone ever experienced this? Suggestions?

GIXERHP

ok, ok...just a wee bit Irish...
Donating Member
Joined
Jan 24, 2003
Messages
14,088
Reaction score
2,980
Check to make sure it is completely plugged in!
Caps was not plugged in all the way at the Bash!

twotonevert

Member of P.E.A.
Moderator
Joined
Aug 28, 2007
Messages
27,234
Reaction score
1,015
Yep, check the plug on the back of the cluster.

SCdude

Registered
Joined
Feb 1, 2011
Messages
48
Reaction score
0
Ok, but will that stop my taillight and signals from workin also?

twotonevert

Member of P.E.A.
Moderator
Joined
Aug 28, 2007
Messages
27,234
Reaction score
1,015
Ok, but will that stop my taillight and signals from workin also?

I want to say that Cap had the same issues, but I am not sure. Start there and let us know what you find.

valkyriemc

Donating Member
Joined
Mar 26, 2006
Messages
677
Reaction score
2
You know, those symptoms are exactly the same as on my '08 prior to getting the ignition replaced, and ignition cables re-routed per the factory recall. I believe a 10 amp fuse was popping. Happened three times before I could get it into the dealership. Been some time since the fix. Good luck.

RussellJ

Rick Rollin'
Registered
Joined
Mar 7, 2010
Messages
7,472
Reaction score
24
Was the issue fixed? I assume it was the fuse?

lankeeyankee

Banned
Joined
May 23, 2011
Messages
3,320
Reaction score
30
Bad Ballast causing fuse to blow Xentech SUX!! I had the same issue with mine.

expat1970

Registered
Joined
Aug 24, 2009
Messages
1,133
Reaction score
4
i had the same issue on my bike ,just happened randomly. turns out when i removed mud flap from rear i cut the license light wire had it tapped up but tape came off and was shorting to ground on rear chassis and blowing the fuse. added butt connectors and secured properly havnt had an issue since

dadofthree

Seasoned Beef
Donating Member
Joined
Sep 6, 2006
Messages
60,244
Reaction score
2,854
On my '06 the low beam quit working after a few months. If I turned the key on and waited 15 seconds I was alright. There's a start up procedure that gets around this issue. I think you press the start switch turn the key on and then pull the clutch in. Hope you got everything else squared away.

Busa21-713

Registered
Joined
Apr 24, 2019
Messages
3
Reaction score
3
Same thing. Cluster, blinkers and tail light out. Replaced fuse twice as it has blown out twice in 2 days. Wtf ? Idk
Back
Top