FAIRING SURGERY

[ToXSicK RoCKeT]

hey peeps, i have a question for the guys running the easy access clutch cover, how did you go about trimming the fairing half moon circle so you could get at the clutch access plate without having to remove the whole fairing? any pics or tutorials on here? and what tool's did you use not to screw the paint up? any and all help would be awsome.....thx in advance.

 

[BigRod1300]

 

[ToXSicK RoCKeT]

 

[Tourbusa1]

Tape, mark, slow razor cut through clear coat and paint, then roto zip or similar with room to file. Then a fine half round file to your finish line filing from the outside in. Careful wet 400 grit sanding will smooth it all out and deburr the backside.

 

[BigBSBusa]

As Tourbusa said, tape and mark, but used a Dremel to cut the fairing then some light filing to get it smooth and door trim to make it look nice.

 

[SHADiGUY1]

its easy rotozip bit on dremel.

 

[rubber2burn]

Just use your teeth and naw through the plastic

 

[Schism]

i used the search and did the leg work for ya! https://www.hayabusa.org/forums/?act=ST;f=11;t=79105;hl=

 

[ToXSicK RoCKeT]

i used the search and did the leg work for ya! https://www.hayabusa.org/forums/?act=ST;f=11;t=79105;hl=

thank you, and to everyone else that replied too....thx

 

[ToXSicK RoCKeT]

Just use your teeth and naw through the plastic  

 

 

 

YOUR PRETTY FUNNY

.........

NOT!!!!!.......maybe throw sum BBQ sauce on there and it might just work

 

[Schism]

Just use your teeth and naw through the plastic  

 

 

 

YOUR PRETTY FUNNY

 

 

.........

NOT!!!!!.......maybe throw sum BBQ sauce on there and it might just work

welcome

 

[Revolution]

lol, cracked me up.