DuraBusaTom
Registered
I installed Core Moto Apex 6 wheels. And now I have an ABS issue. I'm pretty certain it is due to the clearance of the sensor and ring.
The front clearance is ~2mm and the rear is ~.45mm According to another post in this forum the front clearance is too much.
The AMS goes out like it should after I start moving. It only malfunctions at higher speeds. At 130 if I hit the brakes hard the ABS light will come on and stay on until I shut down and restart.
I have reset my front wheel using the Dave Moss video.
Is there a spacer on the rear and I lost it? Can I space the rear sensor out using a washer? Core moto said I could space the front sensor ring out using non-metallic spacers.
The front clearance is ~2mm and the rear is ~.45mm According to another post in this forum the front clearance is too much.
The AMS goes out like it should after I start moving. It only malfunctions at higher speeds. At 130 if I hit the brakes hard the ABS light will come on and stay on until I shut down and restart.
I have reset my front wheel using the Dave Moss video.
Is there a spacer on the rear and I lost it? Can I space the rear sensor out using a washer? Core moto said I could space the front sensor ring out using non-metallic spacers.