Recent content by Jimbusaha

That's very interesting. My circle pins won't budge with my fingers but they do feel oily from the factory. I'll keep a watch on any movement but I'm thinking it would probably occur after the break in period...I'm thinking it might even take a full skidding stop before they would turn. Well...

Hey all I got my new EBC rotor and HH pads on the front wheel and it looks pretty good. I've been breaking it in slowly with no hard braking yet but every time I use them they make the clicking noise. Anyone go through this? Will it go away? I hope so

I just got mine off last night similar to this. I shimmed it up maybe 3/4 between the front grab rail bolt on right side. Took the grab rail bolts off and could get to the front 10mm bolt holding the locking mechanism to the seat. After wiggling it I got both the front plastic hooks off. I...

I got them on today! They don't look exactly the same...no gold on the rear rotor but I'm going with it.... didn't have time to break in the front. Ahhhhhh but guys, I have a new dilemma....Oooh boy...well I put my rear seat down and its locked in but I forgot to connect the cable for the...

Hey I got them both today! The rear isn't excactly the same as front but I'm going with it anyway. I broke in the backs for an initial break-in and test ride but don't have time to break in the front.....oh man I have an other dilemma now I hope someone here can help me ....I put the rear seat...

I think I'm going with these EBC pro-lites ....the front and back look the same

Yep I think I'll go with these pro-lite rotors. The front and back look the same.

Nice!

W Why lightweight? Lightweight = less life?

I have a 2005 busa and never had to change the pads so I need help getting them off. I checked the rotors and the rear is 3.5 mm thick. The manuel says the front can't be less than 4.5 and it's 4 mm. So I guess I'll need rotors unless the minimum isn't that critical?

I searched for info on my air compressor and tried to find an inline fuse but no luck. So I decided to go with the same switch and forget about getting a new fuse I finally found the same switch at Radio Shack put it on in works great I am wondering why the old one went bad but there was no...

Thanks guys...I still need to get back to it being busy lately. Robert, you meant without a fuse, the switch becomes the weakest link? I guess if that's the case I should stick with the same one if I dont get a fuse.... And about the pressure switch.. good suggestion, I did that with my fan...

I didn't install it so I'm not sure if its fused. I didn't see any but good question! I will have to check this week. Thanks for the help so far!

Hi all...I havent been on here lately. This winter has been brutal up here. I would like to be down on those wide open roads that never see the salty dirty snowy icy, ext, ect. Roads! Haha....well anyway I turned on the salamander and and got to work on the bike! I've been dying to ride her but...

Still haven't looked for them again. They are the small ones. Strange that I couldn't find them. I'll look again when I get a chance. I did seriously look for them with flashlight....I will also re-look at the manual. I haven't had much time lately but weekend is calling my name. Nice to be a...