Recent content by FAsT Boy

Route the light under the clutch line and install the "big" clip on the handle bar. Snap the light into the clip and you're done...

Then Tap the hole!!

Next, center punch dead center of left hadle bar and drill about 1/2 inch deep.

Make sure this boot is on the correct side of the connector the FIRST TIME!!!!!!!!!

Retape wires to speedo and connect green to the tach lead. The bundle tucks nicely above the headlight.

Connect black to black and red to brown. Bundle and tape up the extra cable... Don't waste it! You may move the thing later on!

Stip back sheathing on shift light cable and expose 12 inches of wires. leave green alone and cutoff most of black and red. Install male connectors.

Locate Tach lead (yellow with blue stripe) and tap into it with female type connector.

Next locate black & brown wires in nose near right turn signal and install female connectors.

Here is how I installed my shift light. Its out of the way but still VERY visible even in the daytime. First routed wire through the clippy thing and wire tie towards the nose of bike.

Get the pc3 fur sure! It's very user friendly and get it from morepowerracing.com ... they're the cheapest but may take 10days to get.

That's bad arse! It's funny though cause he has a lot bigger investment and the only thing he has over you is he ca carry his purse!!! HAHAHAHAHAHAHAHAAAAAAA!!!!!!!!

i LIKE THE LOOK OF ONE CAN, PLUS ITS LIGHTER AND IT BREATHES BETTER... PUT YOUR HAND BEHIND THE PIPES OF A DUAL SYTEM (NOT MUCH BREATH COMING OUT) AND THEN PUT YOUR HAND BEHIND AN HMF 4-1 CAN. HOLY HELL IS THAT MOVIN' SOME AIR!  THE ONLY THING I DON'T LIKE ABOUT MY HMF IS IT'S TOO LOUD AND...

I never thought I could be so addicted to a motorcycle, let alone a gd website. I'm unemployed with a wife and child, and all I can think about is my bike. I've had my new 03 Busa for a month now and I can't quit spending money on it. This is rediculous. No one ever told me that Busa is a fuggin...

OK I FIGURED IT OUT! It was my PC3usb. It had a program for full muzzy ehaust... I thought I cahnged te program prior to installing it. when I set the program to full stock, smooth as silk again.:;):