Ok so I woke up this morning. Suit up to head to Lejeune Motorsports to get some new grips. As I am riding I say "Hey why not try it out" And it works... I am guessing that the grips were still wet inside and was allowing the Throttle sleeve to actually roll on the inside. So I got some Spider...
Ok so I went in the garage and gave it one last try.. The RPMs still go down, but I don't have to hold it as hard as I use too to keep at speed. I am going to get some new grips tomorrow and see how it turns out... Hope for the best but anything that will allow me release some pressure from my...
i think I will take it in tomorrow and tell them to prove me wrong... I just can't figure it and I am pretty good at rigging things to work... Gotta get new grips anyways so we'll see... Thanks for the help all...
Lol trie that too... Been working on this for about 4hr with different setups.. I am beginning to think I have a faulty setup... One of those rare mix ups..
I used warm water and a little soap.... Yea i know its so straight forward its killing me... I am like WTF!!!! It works perfectly when the engine isn't running but when I roll down the road. Engage it, rpms drop as well as speed.. This is going to keep me up all night...:banghead:
I know i have tried everything. It looks just two brothers. I have adjusted the the clamps and everything. i used the thicker band due to the skinny one not working. It hold when engine isn't running and at half throttle but when I am riding 6 gear I am no where near half throttle doing about...
Hey Org,
I need you help!!! i am planning a 786mile trip to South Florida. I didn't have time to get the Throttlemeister from Pash but don't know if it would work with my Bar End Mirrors anyways. Ok heres the deal... I bought this throttle lock assure by shop it would fit my bike. It was...
k, I think I got this figured out. I use the kit that came from Pashnit with the rearset. Uscrew the Banjo bolt on the Master Cylinder and attached that way. The pressure from applying the brakes with fluid is suppose to activate the switch inside the adapter. Wish me luck I will update everyone.
Yea I got the kit that Pashnit sells with his but I don't know where the H3!! it goes. I will wait a little more and see if they get on. I hope. I really want to ride tomorrow into work.
Ok, finally go the steel lines on and now I am putting the Black Vortex Rearset on. Everything is lined up but now I am totally lost at the Brake Light adapter that I had got from Pashnit with the rear set. I tried to read the instructions on the back of the part but got even more lost.I know I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.