TiForce Full TI Install Today

[nharding]

Finally got my exhaust gaskets in from Schnitz! So I am installing the TiForce today.

The exhaust came with just typed instructions, I've never installed full exhaust on a bike. Does anyone have any pictures to go along with this install or advice?

Thanks

[twotonevert]

Take your time, put some card board in front of your radiator so you dont ding it up.

[Irish]

id just pull the radiator, its not hard, 5 bolts or so not including three for the plastic piece. then you will have room to work.

[Ludicrous Speed]

I always pull the rad, it is easier than working around it and faster, IMO.

[nharding]

Started pulling off the plastic and the oem exhaust last night.

[lil charlie]

I would pull the radiator too, its much easier plus nows as good as time as any to chage out the coolant.

[nharding]

I would pull the radiator too, its much easier plus nows as good as time as any to chage out the coolant.

Yeah I'm gonna pull the radiator and do a coolant flush. It works out perfect because I just started getting some debris in the reservoir tank. Im also going to do an oil change with some alisyn while it's all pulled apart.

[lil charlie]

Do the plugs too and you can call it a complete pre-season tune up!

[nharding]

Do the plugs too and you can call it a complete pre-season tune up!

What are the steps for changing the plugs? I have four on hand but I was just gonna pay someone because I've never changed plug before.

[nharding]

Some update pictures. Exhaust on. Airbox mod. Cut fender.

[smac]

Nice