Hi Everyone,
I'm not sure if this is the right forum to post my query in or not. I have turbo'ed GEN 1 busa motor installed on a sandrail.
I'm currently finalizing the wiring for Motec M150 and I'm looking for some help. I need a base map and this could save a lot of my time. Here's a list of what I have on my sandrail:
Thanks,
Abdulla
I'm not sure if this is the right forum to post my query in or not. I have turbo'ed GEN 1 busa motor installed on a sandrail.
I'm currently finalizing the wiring for Motec M150 and I'm looking for some help. I need a base map and this could save a lot of my time. Here's a list of what I have on my sandrail:
- Gen 1
- Motec M150
- Motec PDM30
- Motec IGN4
- Motec c127
- Wideband
- Oil & fuel pressure sensors
- Bosch fuel pump
- Comp turbo
- Water to air cooling
- Carrillo H Beam Rods
- Wossner turbo pistons
- 50mm Tial Blow Off Valve
- HD valve springs
- Upgraded gears,Back cut transmission, heat treat,30mm counter shaft
- Lock-up clutch
- Fuel Pressure Regulator
- Billet Aluminum Airbox/Intercooler and Secondary Injectors
- Electric Waterpump + custom heat exchanger
- Oil Blockoff
- Crancase Vent Filter
- Spacer Plate
- Adjustable cam sprockets
- ARP cylinder studs
Thanks,
Abdulla
Last edited: