Idle adjustment

[Epstein]

I need to turn the idle up al little and I see the adjustment screw in the owners manual but it doesn't show exactly were it is. Do the
side panels have to be removed to get to it?

[Devious]

No...Just remove the seat and raise the tank...
The adjustment screw is on the right side and easy to reach...


David

[spkerhed]

after you lift the tank look on the right side of the motor turn the throtle you will see where the cables move and the screw is right there

[Charlesbusa]

No...Just remove the seat and raise the tank...
The adjustment screw is on the right side and easy to reach...


David

+1

[motrhedd]

I have a long snap on screwdriver i use to adjust mine without removing anything.If you look between the frame and tank you can actually see the screw.Once you know where the screw is its easy

[omslaw]

I have a long snap on screwdriver i use to adjust mine without removing anything.If you look between the frame and tank you can actually see the screw.Once you know where the screw is its easy

+1 - I just use a long (about 12") #2 phillips. No need to remove seat/raise tank.

[Over_Easy]

Wasn't there an old thread about using Loc-tite or a spring to keep it from loosening again from engine vibration?

[omslaw]

Yeah, some blue loctite will help prevent it from vibrating out. There's a spring on it already, but it's prone to vibrating loose. I popped the tank once to put some loctite on the screw. Since then, I just use the long screwdriver method.

[omslaw]

PS - make sure you use the BLUE loctite - not the Red stuff....or you'll never adjust the idle again!