BEST BUSA MODS!

[OB_badbus]

Airbox mod, Short Stacks, BMC Filter, +2 Rear Sprocket, Reprogrammed ECU with Yosh Box, Genmar, ZG Touring Shield, Escort Passport Radar, Cut Down Foot Pegs and the mandatory Sigma chain.

Up next - Work with Motorhead to get ECU, Throttle Bodies and TPS spot on with the help of his dyno and gas analyzer.

And (Hello Charles) - Schnitz lowering kit, Brock Clutch Mod and Heli bars in combination with my Genmar.

Near future - Akro or Muzzy pipe with PCII.


[This message has been edited by badbus (edited 14 March 2000).]

[Bruce Bohannon]

Many above sound great. Echo brake lines, bar risers (still undecided), would like late model gsxr 750 or tl pegs, brock clutch mod - had to hack the fender when we got home. Pipe and PCII. Tank bra. Need more info about +'s & -'s of air box mod's. But the best no cost mod was to REMOVE ALL THE NONSENSICAL WARNING LABELS. Suzuki - give me a break! OR at least put something down with meaning - Like Warning - Wide Open throttle usage will cause mental, physical and financial ruin. Or Warning - Engine Power produces addiction for which there is NO Cure....

[Bruce Bohannon]

Need more info on the kick stand mod.....

[OB_BUSA1]

FRANK YOUR RIGHT, I TAPE THE OUTSIDE ONES BUT THE ONES OFF THA AIRBOX WERE TO HARD TO GET AROUND. CHECK THE EARLY POST I SEEN ONE WERE ONE MEMBER WENT TO HOME DEPOT AND BOUGHT RUBBER AND CLAMPS THAT FIT. I FORGOT THE DEPT . SOUNDS LIKE THE WAY TO GO , GOING TO LOOK IN TO IT WHEN I GET A CHANCE. GOOD LUCK

[OB_THE MOTORHEAD]

use 2 layers of lockhart 1/4 seat foam and make it seal arount the outside or use silicone hose and clamps.

[Frank Adams]

I think if there was enough foam between each set of tubes, it should be plenty enough to seal it?

[OB_ROR]

Genmar bar riser, Ferodo hi-carbon pads on stock rotors, Valentine 1 mounted inside fairing with remote display and remote audio control, polished/clear powder-coated wheels, Two Brothers round polished slipons with stock settings (PC II is next), GSXR 750 front pegs.