3D printed lighter parts for Gen 3

[Robert 0046]

If you have the chance to 3D print any part of the bike to make it lighter keeping in mind the safety always wich one would you make?

[Robert 0046]

Very nice fitment and durability tank bracket made by Eric Moore.

[pcs]

it’s a nice fit but not a very durable part imo.

[Robert 0046]

it’s a nice fit but not a very durable part imo.

Im using mine with no problems so far

[pcs]

not durable doesnt mean it doesnt work. when your pivot the fuel tank up and down, that bracket flexes. its not a longer term part imo.

[Robert 0046]

not durable doesnt mean it doesnt work. when your pivot the fuel tank up and down, that bracket flexes. its not a longer term part imo.

When pivoting the tank i always try to do it when empty. In the dropping weight dep. And for my needs it works fine and just right.

[Robert 0046]

not durable doesnt mean it doesnt work. when your pivot the fuel tank up and down, that bracket flexes. its not a longer term part imo.

When pivoting the tank i always try to do it when empty. In the dropping weight dep. And for my needs it works fine and just right.

[Dai.]

not durable doesnt mean it doesnt work. when your pivot the fuel tank up and down, that bracket flexes. its not a longer term part imo.

Depends how often you're lifting the tank up and down.

[pcs]

if u put a straight edge under the main support bracket and pivot the tank up and down as you do normally for basic service you can see it bends a little. when the tank is mounted. the weight is distributed and everything is fine. functional is not the same as durable. sometimes a person has to compromise.