Recent content by Whiskeyer

I used something similar with a cbrf4i on my grand Cherokee. I went all over the country with it. I didn't have any place to store a trailer. I did have it strapped down with more than a few tie downs.

hey guys, before I took apart the clutch lever I wanted to get your advice. There is a rubber gasket/tube at the base of the clutch lever. When I pull in the lever, it pops or clicks. Is this something I can just move back into place or do I need a new one? Is this something that will hurt...

Now, in my defense. I'm an idiot. Thanks fellas. As an aside, the pop rivets with the screws in them are an absolute pain.

I'll double check but it looks like it connects the subframe but not the seat. Thanks for the reply... Are you using ms paint? ;)

hey guys, new bike and I'm about to double check the pc3. I cannot for the life of me figure out how to get the tail section off...or the seat for that matter. Any ideas? The bolts on the side are frame only. I can't pull the tank side of the seat. There are two small screws in the back but...

I definitely need to install a speedo healer as well. Pretty straightforward? I'm off by 29% right now.

Geico saved me 50% over progressive. 800 year for full coverage 34 years old, clean driving record. I'm pretty thrilled with the price. Liability only is about 10/month if I wanted to

Welcome! Double welcome if you're a cyclone!

To each his own I suppose, I had a gsxr 1000 before this and I'm lucky the previous owner starting dumping weight. It's been a weird transition having to actually lean and counter steer into the turns.

Just wanted to stop in and say hello. I'm a serial lurker, but I'm so proud of my new bike that I had to sign up to show it off. Full Yosh, k+n, pc3, gsxr tail, +5 rear sprocket, de restricted ecu. even coming from a gsxr 1000, this thing is a riot to drive. First mods that I'm doing are...