Recent content by Sliver

Did it to mine recently. All you have to do is loosen the shifter where it connects to the bike and flip it around. You'll also have to lengthen the reach rod to get the shifter at the right hieght. It takes about one minute to do but you'll have to experiment with it to get it in the right...

Alot of you guys seem to be paying quite alot for insurance. I'm 22, and married and I only pay about 300 every six months for the busa. I've got state farm but I also have two other vehicles insured with them and homeowners insurance with them.

Check out "New HMF exhaust" in the general section

My busa overheated in traffic this morning. All of a sudden it started smokin. I pulled over and checked it out and low and behold the temp sensor on the radaitor was unplugged so the fan wouldn't turn on. The weird thing is that the plug was shoved up into the fairing so it's not like it...

You can't just replace the faces. The 185 gage would still mark speed the same but the 220 face has smaller increments. So your gage may indicate 220 but you'd only be going 185. Hope this helps, sorry but I don't know where you'd get a whole new gage. Luke

I called hmfengineering, the numbers on their website. Cost was $1199.00 plus shipping. You can also get them from hayabusaparts.com but they want you to pay extra tax when using a credit card, so even though they're $100 cheaper you don't save as much and I would rather deal with the...

Hey Fuego, welcome to the board. If your looking for highmounts that keep the passenger pegs go to hmfenginering.com. They're the only highmounts that I've seen that keep the peg. Check out "new HMF exhaust" in the general section. I've posted pictures of my bike and its got the HMF dual highmounts.

here's the rest

and heres where the undertail doesn't fit as well as it used to

Got some better pics. Heres where the rear cowling hits the footpegs.

The spacers came with the exhaust but if you dont keep the passenger pegs you wont need the spacers. I kept the pegs so when i put the rear cowling back on it hits the bracket for the pegs pushing the sides out a few millimeters. This causes the undertail to not fit as well as it did before...

Hey, dezzy7, I got the undertail from alliedbarter.com. If you call tell Silvio your a member of this board and he'll give you a deal.

I went to d-tect security just to chek it out and i had to by one. Got the alarm with pager for only $99 and that was the most expensive one. If your looking for an alarm i'd chek these guys out.