found it thanks lantabusa. now the problem is, im not good with electronics. so if anyone can tell me where to put the 600 ohm resistor that would be great. at least if that is in fact the problem. i just talked to jim at sunrise auto & cycle and he told me to send it back and he'll send me...
WELL, I TOOK THE BIKE TO THE DYNO TODAY RESET THE MAPPING BACK TO STOCK HOOKED UP THE PCII AND DID A COUPLE OF RUNS. THE BIKE RAN LIKE S--T. AND WHEN YOU WOULD LET OFF AFTER A RUN THE BIKE WOULD DIE. WHEN YOU TRY TO START IT THE FI LIGHT WOULD BLINK ON AND OFF AND WOULD NOT START. TRIED A COUPLE...
thanks omega ill email him now, yea lets try and get there arond 9-9:30. im going to install it tonight. i hope if all goes well thanks again omega. when we gonna hook up? eric
Ok i have a new pcll but i have my map set at 5,5-5 by a yosh box. how can i get it back to the stock settings so i can install the pcll? thanks in advance. eric
joe, i will be there with the wife. if the weather is good we'll take the bike there. ill call during the week to see if u need anything or u can let me know here or email me. eric
WITH A FULLY MODDED BOX AND A YOSH DUPLEX- FULL EXHAUST WHAT SHOULD THE MAP SETTING BE WITH A YOSH BOX? ALSO, IF YOU GO RICHER WILL IT DECREASE THE HP READINGS ON A DYNO IF IT DOES NOT HAVE ANYTHING TO PRODUCE AIR IN THE RAM AIR? MEANING THE NUMBERS MAY BE HIGHER IF YOU LEAN IT OUT ON THE DYNO...
LYLE OR MH I WOULD LIKE TO KNOW ABOUT THIS. I TOO HAVE THE EBC HH AND I TOO HAVE THE HEAVY DRAG. I CAN NOT FIND THE POST Y0U ARE SPEAKING OF. THANKS FOR ANY HELP. ERIC
DOES RED LINE FUEL CLEANER AFFECT THE HP? LAST WEEK I DYNOED MY BIKE AND THE NUMBERS WHERE A LOT LOWER. OF COURSE THIS WAS JULY AND THE LAST ONE WAS DONE IN FEB. I HAD FORGOT ABOUT RED LINE AND HAD A FULL TANK. MAN THAT WAS NOT GOOD, THE HP # THAT IS. ALSO, DID THE PAIR VALVE. IF THERE WAS EVEN...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.