I've taken this thong apart many many times. Stack height is right. I have tried anywjere from 49.5mm to 50.5 mm. Still doesn't change anything. Everything is orientated correctly and in the right spot.
I am curious if my master cylinder is not moving the slave cylinder enough.
The clutch will not disengage.
I checked it all out again. The pressire plate was hitting the inside of the clutch cover. The stack appears to check out too @ 2 inches.
I cleaned the slave cylinder. If I pull the clutch in while the trans is in gear I can not roll it still. The pressire...
Thanks guys.
This is a 2007 gen 1 with very little miles in an off road car.
I have a slave cylinder support bracket on it, always have from day 1.
I took the clutch cover back off and the stack out, everything is in there correctly. I pull the clutch and just don't see the pressure plate...
Good morning
Does anyone know what the travel is on the clutch slave cylinder?
I put a new clutch pack and HD springs in and now the clutch will not disengage.
The clutch stack is 2.00 inches
The line has been bleed, no air
All the plates including the last one is in correctly.
It all...
I have an 07 busa engine in my off road car. I need a low fuel light. Because of the shape of the tank there is no float on the fuel pump assembly.
My guge always reads empty and the low fuel light on. I dont care about the gauge....but a low fuel light would be nice and is needed.
Does...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.