Recent content by minsc_tdp

If it's a bad map I'd be highly annoyed. I paid nearly $700 to Mach1 of Costa Mesa, CA, who came highly recommended. For this, I got the PC3, installed, with several hours of tuning on a dyno to make a custom map. It was extremely smooth after that. So I don't think it's the map, as this...

Thanks, I didn't do any real work to her myself, I bought it used, the previous owner added a lot of chrome. Too late for sliders, already dropped on each side, damage done. As for vent guards, are they just aesthetic or do they have some function?

I know a strong bike like this is going to buck and want to go, but it's pretty bad. The best example of real-world issue is, when attempting a low speed, tight u-turn, it is somewhat difficult to go at the speed I want. I'm forced to give more throttle than I want, and that forces me to take...

Thanks all. Pics here: http://knepfler.com/busa

I got the bike used, it already had a TRE. I added a PC3 and that seemed to make the problem worse. After a dealer servicing it seems to go away for a while, I think maybe they're adjusting the throttle bodies or something, I'd just like to know what it is so I can do it myself. The PC3 didn't...

Ok I know I just posted three times in a row, but I didn't want to overload one topic with 3 things. My last issue is that the throttle doesn't seem to be steady between about 1000 and 1700 RPM. Meaning, when I try to hold the throttle still and cruise at low speed at that RPM, the bike surges...

So I've had the typical idle problems, where it drops after a month or two and needs to be adjusted. Did it myself this time, dialed it in just right, idles at 1100 when warmed up fully. Only problem is now, when starting cold, it idles around 800 and the choke (fast idle) lever, it does...

Crashed into a car at very low speeds. No major damage, just the front fender and the bike fell on its left side (far less fairing damage then when I dropped it on its right side!) The clutch handle broke off. I just replaced it and during this, the pin came out quite a bit. My brother told me...