Recent content by m2cyclone

Duh, :) I guess I was over thinking it and thought the PC3 controlled that.. forgot about the idle adjust screw.. thanks

then my idle is way off then.. tach shows about 900.. how to fix that?

Im using a map file that one of the guys on here sent to me. It seems to work fine for my setup, but at 0% throttle, it will sometimes stall. Most of the time when pulling up to a light, when I pull the clutch in it will stall or sometimes when you rev it up and then go to 0% it will stall...

thanks, I'll probably get a pair and try them out.

Thanks Bogus, thats how it fits now..

Yes the chrome shop sent me a GSXR600 wheel by mistake.. so I was also curious if the cush was wrong too. But if the cush does not touch the rear wheel then I think I am ok. I put the Cush on last night and it slightly sits inside the rear wheel. thanks

I sent my wheels and Cush drive off to be chromed and got back a GSRX600 wheel, and then they swapped me another rim that was wider, 6inch. So now I'm not sure if the Cush drive is a 600 or not. So my question is, how does the cush drive fit to the rear wheel. - Is the Diameter of the Cush...

the first pic was the top of the lip picture. where I got 6inch width. the next one is of the bottom lip or bead. this is where I get 5 1/2 inch..

I just got a set of wheels from the Chrome shop for my 05 Busa. They shipped me a GSXR-600 Rear Wheel, its engraved on the inside of rim. I've read on here were the those bikes have a smaller width. 5,1/2 compared to the busa 6 inch. Question is, where do you measure this width at. It...

I found a 4into1 Micron system on ebay. Is this a good exhaust to get? I do not have a commander, but will get one in the future. Is it ok to put the new exhaust on and ride it and then add the commander later. Will this hurt my performance or really not noticable until I get the commander...

I found a HID conversion Kit on ebay for $114. Does anyone know if this is a good kit or not. Its sold from starrotors.com http://cgi.ebay.com/ebaymot....RS:1123 thanks in advance

I don't have pics, but its those aftermarket bolt caps that you can get to cover ugly bolt heads.. these are the 4 bolts that hold the handle bar dampner to the top triple tree.. I'll give the razor a try.. thanks

Does anyone know how to remove those aftermarket bolt caps on the handle bar damperner. I bought the bike and it has these chrome caps over the bolts and I would like to take them off so I can put on a chrome triple tree and damperner. I would like not to scratch these up, so i can use them...