Recent content by jthevwman

Up date Rust is out of the tank and a new / used fule pump installed, dam the cast $490 new. It runs about 85% better. runs the best when warm up .

found rust in the tank . A lot of rust in rear lower part of the tank. So i think the fule pump is shot. Any fixes on the rust in the tank? Ideas??

Have not checked the timing.. It does do this in every gear. It runs better not right but better when it gets hot.. when it gets up to running temp it runs a little better . when you take off in first gear it wants to die the you have to fan the clutch to get it to go..

I think the batt may be going bad ?? My friend ran his with a bad batt and it ran fine ?? could this do any thing to the bike to make it run bad ??

1. I would open the air box and observe whether or not the flapper is opening. Done it is checked out good 2. You may need to remove the air box to observe that all 4 throttle butterflies are opening and at the same time. Done checked out good. 3. Make certain all spark plug caps are fully...

I tryed the batt trick it runs the same . I dont have a PC so will this work for clearing the stock codes???

No FI light on how do i pull codes?

All stock no PC 11 K miles 2002 year

I bought the bike thinking it has a vacume problem. I checked all the lines they are good. The bike runs like **** when cold, wont rev up and dies untill it gets warm.. Then it has flat spots all through the RPM's even when hot. You have to fan the clutch to get it to go. wont pull the tire...