Hey man, you are welcome. I have a little bit left to do and purposefully heat shrunk my wires in clear so I have taken pictures etc.
I am happy to put them up with a step by step guide in wiring up a remote keyless ignition. It would be specific to the one I have donw, but I sure wish I...
I have managed to wire it in. Thanks to you all for your help. And yes, a 100 ohm resistor is needed otherwise the ECU light comes on and it won't start!
I would really appreciate some help here. I am about to give up on this forum. I have asked for help a few times and no one ever really bothers. Pretty please? Until someone helps me out with a wiring diagram or something I cant ride my bike, Im sure if that was one of you, you would be...
Thanks mate, I appreciate the contact, but I already have the Switch. My problem is the only wiring diagram I can find is Gen 2 Busa. If I can find the Gen 1 I should be able to just compare them as I have instructions to wire to Gen 2.
Hey everyone. Someone tried to steal my 2005 Busa and smashed the ignition and the metal housing to bits :(
I am going to put a keyless ignition in, but, I have no idea of the wiring and cant find it anywhere!
Is anyone able to help out with letting me know:
Wiring to ignition...
Hey guys I'd like to wire the speed sensor and the engine coolant temp sensor to my pc5 on a 2005 model. Does anyone know what two wires to tap into? Also can you tap this directly at the ecu or is it best to do it at the sensor itself?
I ended up with some U shaped rubber floor seal strips. The are weather and UV resistant so I got a metre for 7 bucks. Cut them and glued them with a gel glue to the outer fairing lip. Also got dome sticky back door Foam, to fill above the clocks.
Pics are before I screwed the fairings back...
Yeh I put the old undamaged nose back on to check and the inner fairings fitted again, the curve in the new fenders sits a little higher and ends up being a different shape than the rim of the inners. I imagine it will be the same with the carbon fiber inners, so I am all ready to door seal it!
Sorry been away! I got them all from MDI Carbon Fiber. They have sent the inner panels and back end out today so I will be getting on with it all soon. I have asked them to send out some carbon fibre matting too, I will try tacking that to the door seals and see if it makes it look nice. Ill...
Thanks GixerHP, I am definitely sure, the Original nose only had a couple of short light scratches, and I have tried putting it back on and everything fits together again. I was advised to check this in a previous post I made. The only think I had physically changing my setup was nose fairing...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.