found it, turns out to be orange w/ red tracer is constant and yellow is temporary once the switch is engaged. but i think i fried my garage door opener in the process lol
I am going to do a GDO mod on my 07 Busa. i have the opener ready to go and want to connect it to the pass button. does anyone know which wires run to this switch from the upper end of the harness? Im assuming I shouldnt have to actually open up the switch its self, but rather just tap in to the...
i looked through their inventory and decided to let them sell me. They have a ton of different items. so i emailed them with what i have and what i want to do and requested a price and parts sheet. will post what they reply here as well. basically im looking to rebuild my forks with stiffer...
Ok, so I now have a fork seal that is leaking pretty good. I will take it down this winter and want to rebuild both fork tubes. I am a bigger guy (6'1" and 245), and as we all know the forks could use stiffer springs anyhow. Does anyone have a recommendation on parts for the rebuild including...
Huge difference. You are correct on the factory sprocket sizes. Basically you are transferring a lot more torque to the rear wheel. with that your speedo and odometer are going to be way the hell off with that set up. If you are a normal rider I would go back to the stock setup.
Omslaw is right John, it actually is a square bit even though it doesnt look like it should be. And as far as the screw goes Omslaw, shoot me an IM with your address and I will mail you some. Other wise they can be had by calling our plant and ordering them in quantity.
*edit* Just noticed you...
Just dropping my .02 after some exhaustive searching.
Farm Bureau-
These people are the stuff. I currently have my house two cars and my Busa through them. They saved me gobs on my home insurance and hit me the lowest on the Busa. Basically im paying about $80 a month for full coverage on...
I thought I would throw this out there. Professionally I work for Interstate Cargo (or TrailersPlus), the manufacturer of the LoadRunner enclosed trailers. I can generally answer any question about any brand enclosed trailer, as this is what I do. If you have a question regarding quality...
Front sprocket should be real tight and we always use an impact to take off and put back on. But a big azz cheater bar would be good too. Make sure your rear wheel is as aligned as possible when you put it back on. Also if you have extensions or an extended swing arm dont over tighten your rear...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.