Recent content by hefty01

Thanks for the help guys i will make sure they are degreed when installed always get lots of great information from this site thanks again will let you know what i think when installed

So i take it they must be degreed regardless to get best results at what settings forgive my lack of knowledge i am new to this and just want to make sure it is done right wish i could come and see you Johnny just a little to far to travel from Australia thanks for help

Thanks Busa Reds just want to get it right have done all my mods using infomation from this site and motor has never been apart . What improvement in power would you see from cams have yoshi 4 into 1 tri oval pc3r and small airbox mod . Got 158 hp all standard .

what would happen if not degreed in and what settings thanks as i am being told they do not need to be degreed thanks for any help

Just after some advice i have purchased some yoshi stage one cams with sprockets already on do cams need to be dialed in or is it not needed . I am not sure what they mean by dialing in cams , do not plan on installing them just looking for some advice as am being given two explanations one is...

Thanks guys i am about 280 pounds with gear on

Sorry mate a little further away Australia

Bike is lowered 1 1/4 " front using genmar risers and 2 " rear when using strap at track only how much lower would you go or would you not recommend using strap as well thanks for any help as only new at this

Best 10.6 at 138 mph 60" 1.8 very limeted experience all stock except 16 tooth front . New mods yoshi full system lowered and yoshi cams . Lowered 1 1/4 " front if i use strap how much lower would you go . Still way to slow 60" just need more practice some of the times you guys are doing are great .

I have used genmar risers to lower front 1 1/4 " and adjustable links in rear lowered about 2 " .When using strap at drags how much lower would you recommend going only using strap to race .

Thanks anybody else used yoshi cams or would you recommend another brand

Just wondered if you guys would recomend yoshi stage 1 cams and what sort of horsepower gains could be expected . Current mods yoshi tri oval dual outlet system and pc3r also airbox mod loking to do next mod what would you recommend.

I went with yoshi tri oval dual outlet

PC3R

I have the screw type adjustable lowering links from schnitz racing good product just be sure to measure both sides the same when adjusting.